Forwarding Scanned Data To The Computer Using The Operation Panel Of The Machine - Canon MG2100 Series On-Screen Manual

Forwarding Scanned Data to the Computer Using the Operation Panel of the M...
> >
Home Scanning Scanning with Using the Operation Panel of the Machine
to the Computer Using the Operation Panel of the Machine
U051
Forwarding Scanned Data to the Computer Using the Operation
Panel of the Machine
You can forward the scanned data to the computer using the operation panel of the machine.
The machine detects the type of the originals loaded on the platen glass automatically and the image is
forwarded to the computer in the optimized size and resolution.
Important
Load originals properly according to their type; otherwise, some originals may not be scanned
properly.
For details on how to load the original on the platen glass:
Loading Originals
The following items can be scanned:
Photos, postcards, visiting cards, magazines, newspapers, documents, BD/DVD/CDs
The following items cannot be scanned properly.
A4 sized photos
Documents smaller than 5 inches x 7 inches (127 mm x 178 mm) such as a paperback with its
backbone cut off
Originals on thin white paper
Long and narrow originals such as panoramic photographs
Before forwarding scanned data to the computer, confirm the following:
The necessary application software (MP Drivers and MP Navigator EX)
is installed.
If the application software (MP Drivers and MP Navigator EX) is not yet installed, insert the Setup CD-
ROM into the computer's disc drive, then install MP Drivers and MP Navigator EX.
The machine is connected to a computer correctly.
Make sure that the machine is connected to the computer correctly.
Do not plug in or unplug the USB cable while the machine is in operation, or when the computer is
in the sleep or standby mode.
The destination and the file name are specified in MP Navigator EX.
You can specify the destination and the file name in MP Navigator EX. For details on settings of MP
Navigator EX:
Scanner Button Settings Tab (Save to PC)
Note
When scanning with using the operation panel of the machine, the document type is
automatically detected and the settings in document size and resolution are automatically set.
1.
Make sure that the machine is turned on.
Confirming that the Power Is On
2.
Load the original on the platen glass.
Loading Originals
3.
Press the SCAN button.
Scanning starts and the images are forwarded to the computer according to the settings specified in
This manual downloaded from http://www.manualowl.com
Page 278 of 731 pages
> Forwarding Scanned Data