Installing The Usb Device; Removing And Replacing The Battery - HP Compaq GT7720 Hardware Reference Manual

Installing the USB Device

Before beginning the replacement process, review
on page 11
Insert the USB device into the USB port in the secure USB compartment. See the following
▲
illustration for the location of the ports in the secure USB compartment.
Figure 2-9

Removing and Replacing the Battery

Before beginning the replacement process, review
on page 11
WARNING!
power cord is disconnected from the electrical outlet.
To remove and replace the battery:
1. Locate the battery on the system board.
ENWW
for procedures you should follow before and after installing or replacing hardware.
USB ports in the secure USB compartment
for procedures you should follow before and after installing or replacing hardware.
Before removing the side access panel, ensure that the thin client is turned off and the
General Hardware Installation Sequence
General Hardware Installation Sequence
Installing Thin Client Options 19