Installing Thin Client Options
Various options can be installed on the thin client:
●
Installing the USB Device on page 18
●
Removing and Replacing the Battery on page 18
●
Installing the PCI-Express Card on page 19
●
External Drives on page 20
Installing the USB Device
Before beginning the replacement process, review
on page 10
for procedures you should follow before and after installing or replacing hardware.
Insert the USB device into the USB port in the secure USB compartment. See the following
▲
illustration for the location of the ports in the secure USB compartment.
Figure 2-9
Removing and Replacing the Battery
Before beginning the replacement process, review
on page 10
for procedures you should follow before and after installing or replacing hardware.
WARNING!
power cord is disconnected from the electrical outlet.
To remove and replace the battery:
1.
Locate the battery on the system board.
18
Chapter 2 Hardware Changes
USB ports in the secure USB compartment
Before removing the side access panel, ensure that the thin client is turned off and the
General Hardware Installation Sequence
General Hardware Installation Sequence