Quad-Head Configuration; Installing The Rubber Feet - HP Compaq GT7720 Hardware Reference Manual
Hp compaq gt7720: reference guide
Hide thumbs
Also See for Compaq GT7720:
- Getting started manual (73 pages) ,
- Troubleshooting manual (73 pages) ,
- Manual (8 pages)
Table of Contents
Advertisement
(3)
Universal serial bus (USB) connectors (4)
(4)
PS/2 connectors (2)
Quad-head Configuration
NOTE:
This applies to the HP gt7725 thin client with expansion module.
The quad-head configuration is only available with the HP gt7725 thin client
Figure 1-5
(1)
DMS-59 connector for DVI-I outputs (2) (splitter cable
included)
(2)
S-Video out (not supported)
(3)
Line-out (headphone) audio connector
(4)
Ethernet RJ-45 connector
(5)
Universal serial bus (USB) connectors (4)
Installing the Rubber Feet
To install the rubber feet:
1.
Locate the holes in the corners of the left side of the thin client.
2.
Remove the feet from their backing.
ENWW
Rear panel components
(7)
Serial connector
(8)
Power connector
(6)
PS/2 connectors (2)
(7)
DVI-D connector
(8)
DVI-I connector
(9)
Serial connector
(10)
Power connector
Installing the Rubber Feet
5
Advertisement
Table of Contents
