To replace the access panel:
1.
Place the access panel on the side of the unit, offset about 6.35 mm (1/4 inch) toward the rear of
the unit (1).
2.
Slide the panel toward the front of the unit until it locks into place (2).
3.
Replace the screw that secures the access panel to the chassis (3) or expansion module.
Figure 2-8
Installing Thin Client Options
Various options can be installed on the thin client:
●
Installing the USB Device on page 19
●
Installing the PCI-Express Card on page 20
●
Installing the PCI-Express Card on page 20
●
External Drives on page 21
18
Chapter 2 Hardware Changes
Replacing the side access panel
ENWW