Adjusting Steering Head Bearing Play; Lubricating The Steering Head Bearing; Removing Front Fender - Husqvarna TE 250 Owner's Manual

12 SERVICE WORK ON THE CHASSIS
12.12
12.13
12.14
62

Adjusting steering head bearing play

H03689-10

Lubricating the steering head bearing

H02387-01

Removing front fender

Preparatory work
–
Raise the motorcycle with a lift stand. (
Main work
–
1
Loosen screws . Remove screw
–
Loosen and retighten screw
Guideline
Screw, top steering
head
–
Using a plastic hammer, tap lightly on the upper triple clamp
to avoid stresses.
–
1
Tighten screws .
Guideline
Screw, top triple
clamp
–
Mount and tighten screw
Guideline
Screw, top M8
steering stem
Finishing work
–
Check the steering head bearing for play. (
–
Remove the motorcycle from the lift stand. (
–
Remove the lower triple clamp.
–
Install the lower triple clamp.
Info
The steering head bearing is cleaned and lubricated
in the course of removal and installation of the lower
triple clamp.
Preparatory work
–
Remove the headlight mask with the headlight. (
p. 55)
2
.
3
.
M20x1.5 12 Nm (8.9 lbf ft)
M8 17 Nm (12.5 lbf ft)
2
.
17 Nm (12.5 lbf ft)
Loctite
p. 61)
p. 55)
( p. 58)
( p. 59)
p. 111)
®
243™