Husqvarna TE 250 Owner's Manual page 98

13 BRAKE SYSTEM
96
–
Remove the brake linings.
–
Clean the brake caliper and the brake caliper bracket.
–
Check that spring plate in the brake caliper and brake pad
sliding plate in the brake caliper bracket are fitted correctly.
–
Insert the new brake linings.
–
4
Mount pin
The spring plate engages in the groove on the pin.
Info
Always change the brake linings in pairs.
–
Mount cotter pins
–
Operate the foot brake lever repeatedly until the brake lin-
S04472-01
ings are in contact with the brake disc and there is a pressure
point.
–
Correct brake fluid level to marking
Brake fluid DOT 4 / DOT 5.1 (
–
Mount and tighten screw cap
shim.
Info
Use water to immediately clean up any brake fluid that
has overflowed or spilled.
S04468-10
–
Mount new cable ties on the frame protector.
.
3
.
A
.
p. 155)
1
with membrane
2
and the