Husqvarna TE 250 Owner's Manual page 122

16 COOLING SYSTEM
120
–
Pour coolant in up to level
Guideline
Coolant level
radiator fins
Coolant (
400243-10
–
Push protection cap
ture sensor.
H03761-10
–
Unplug connector
–
Remove coolant temperature sensor
until the coolant escapes without bubbles.
–
Mount and tighten the coolant temperature sensor
O-ring.
Guideline
Screw, cylinder head
temperature sensor
H03762-10
–
Plug in connector
–
Position protection cap
–
Pour coolant in up to level
Guideline
Coolant level
radiator fins
Coolant (
400243-10
–
Mount radiator cap
Danger
Danger of poisoning Exhaust gases are toxic and
inhaling them may result in unconsciousness and
death.
–
Always make sure there is sufficient ventilation
when running the engine.
–
Use effective exhaust extraction when starting or
H03763-10
running the engine in an enclosed space.
–
Allow the engine to warm up and cool down again.
–
Check the coolant level. (
A
above the radiator fins.
10 mm (0.39 in)
A
above the
p. 155)
2
upward over the coolant tempera-
3
.
4
with O-ring and wait
M10x1.25 12 Nm (8.9 lbf ft)
3
.
2
.
A
above the radiator fins.
A 10 mm (0.39 in)
above the
p. 155)
5
.
p. 118)
4
with