Siemens IQ500 CP465AGB0 Series Instruction Manual page 33

Error message
Collecting tank is empty after operation.
White lime scale particles are in the col-
lecting tank.
Low water consumption in combination
mode. Especially in combination mode
with 3 functions.
"‹†„ƒ.
"†‹‹†.
Possible cause
In steam / steam combination mode, the conden-
sation is collected by the glass plate on the cook-
ing compartment floor and the grey drip tray in
the bottom plate. The condensation does not
reach the collecting tank.
During rinsing or descaling, fine particles of lime
dissolve out of the boiler.
In steam combination mode, especially with
3 functions, it may be that only small amounts of
steam are used. Therefore, only little water is con-
sumed from the fresh water tank.
Dirt on the control panel is creating a touch field
that is permanently active.
The steam function has been activated multiple
times with an empty water tank.
Trouble shooting
Remedy/Note
The collecting tank serves only the rinsing and descal-
ing process, not the normal steam / steam combina-
tion mode. See also chapter "Steam".
During rinsing and descaling, stuck lime particles may
come loose. Check the water hardness setting. Per-
form the descaling process at the recommended
intervals.
No malfunction.
Switch off the appliance and clean the control panel.
Switch the appliance on again.
If this fault recurs immediately after switching back
on, call our customer service.
Before next use, make sure that the water tank is filled
with cold water and fully inserted in the tank recess.
If this fault recurs, call our customer service.
en
33