Toshiba MCY-MHP0506HT Owner's Manual page 15

1FAN_OM_EHV0000101-01.book Page 14 Thursday, September 13, 2018 5:10 PM
1-way cassette type (YH series)
Vertical adjustment
When cooling
Point the louver horizontally to send cool air across the
entire room.
When heating
Point the louver downward to send heated air to the floor.
Horizontal adjustment
To send air horizontally, point the vertical grilles inside
the louver in your preferred direction.
NOTE
To improve the cooling / heating performance, change
the louver angle for each running mode.
EN-27
Floor standing type
Vertical adjustment
When cooling
Move the louver manually and point it horizontally to
send cool air across the entire room.
When heating
Move the louver manually and point it downward to send
heated air to the floor.
Horizontal adjustment
Sending air in different directions
Lift up the vertical louvers slightly and point them in your
preferred directions.
2
1
In this case, do not use the
auto swing function.
– 14 –
Floor standing cabinet type
When cooling
Move the louver manually and point it horizontally to
send cool air across the entire room.
When heating
Move the louver manually and point it downward to send
heated air to the floor.
Owner's Manual
Changing the air discharge
Follow the procedure below to change the air discharge:
1
Remove the two fixing screws of the air
discharge. (The fixing screws are to be reused)
2
Insert your hand into the air discharge and pull it
up slightly, then remove the air discharge from
the claw hook at the rear side.
3
Lift up the air discharge and remove it.
4
Reverse the air discharge and reattach it to the
main unit.
Make sure that the four claw hooks (2 at the rear
and 2 at the lower sides) are hooked into the
mounting positions.
5
Be sure to tighten the air discharge with the
removed fixing screws so that it does not come
off.
EN-28