Caution - Toshiba MCY-MHP0506HT Owner's Manual

1FAN_OM_EHV0000101-01.book Page 13 Thursday, September 13, 2018 5:10 PM
NOTE
To improve the cooling / heating performance, change
the louver angle for each operation.
To set the air discharge direction to
forward using a front air discharge unit
(sold separately)

CAUTION

When applying a front air discharge unit to the
indoor unit, the 2-way air discharge function
(forward + downward) is not available.
Such use may lower the air temperature and cause
water leakage.
For details on the installation, read the installation
manual that comes with a front air discharge unit (sold
separately).
When using a front air discharge unit (sold
separately) for an indoor unit of the 1-way cassette
type, follow the procedure below to change
discharge direction:
Vertical adjustment
When cooling
Move the louver manually and point it horizontally to
send cool air across the entire room.
Louver
When heating
Move the louver manually and point it downward to send
heated air to the floor.
EN-25
– 13 –
NOTE
1 When sending air downward, bend the louvers evenly
as shown in the following figure.
If the air flow is blocked, water droplets may fall down
from the air discharge.
NO GOOD GOOD
Louver
2 Set the angle of the louver to 40° or lower.
If the angle is over 40°, droplets may fall down.
40° or lower
Horizontal adjustment
Use the vertical grille behind the louver to even the room
temperature.
Vertical grille
NOTE
When adjusting air direction horizontally, arrange the
angles of the vertical grilles gradually as shown in the
following figure.
If the air flow is blocked, water droplets may fall down
from the air discharge.
NO GOOD
Vertical grille
GOOD
Ceiling type
Vertical adjustment
When cooling
Point the louver horizontally to send cool air across the
entire room.
When heating
Point the louver downward to send heated air to the floor.
• The louver automatically points upward when running
is stopped.
• In pre-heating mode, the louver points upward.
The swing indication appears on the remote controller
even in pre-heating mode, but the actual swing starts
only after pre-heating is complete.
Horizontal air flow adjustment
To change the horizontal air flow direction, point the
vertical louvers inside the horizontal louver in your
preferred direction.
NOTE
• When the horizontal louver is pointing downward in
COOL mode, water droplets may form on the surface
of the cabinet or louver and drop down.
• When the horizontal louver is pointing horizontally in
HEAT mode, the air may not warm up the room evenly.
Owner's Manual
1-way cassette (YH series), and
floor standing types
Setting the direction and swinging
1
Push the SWING/FIX button during running.
If 1 remote controller controls 2 or more indoor units,
you can configure the direction setting for each unit
individually.
Push the SWING/FIX button again while the louver is
swinging.
2
You can stop the louver in your preferred
position.
TEMP. ON / OFF
TIMER SET FAN MODE
TIME SAVE A A VENT
FILTER L L
RESET TEST SET CL SWING/FIX UNIT LOUVER
1, 2
Unit select
Unit select
• When two or more indoor units are controlled with one
remote controller, the louver direction can be set for
each indoor unit by selecting them individually.
• To set louver direction individually, push the UNIT LOUVER
button (left side of the button) to display an indoor unit
number in the control group. Then set the louver
direction of the displayed indoor unit.
• When no indoor unit number is displayed, all indoor
units in the control group can be controlled
simultaneously.
• Each time you push the UNIT LOUVER (left side of the button),
the indication changes as follows:
No Unit No. Unit No.
display 1-1 1-2
Unit No. Unit No.
1-4 1-3
EN-26