Toshiba MCY-MHP0506HT Owner's Manual page 12

1FAN_OM_EHV0000101-01.book Page 11 Thursday, September 13, 2018 5:10 PM
3
Push the SWING/FIX button to confirm the direction of
the selected louver.
Each time you push the button, the indication
changes as follows:
(1) (2) (3) (4)
(7) (6) (5)
* When cooling or drying, (4) and (5) are not displayed.
Setting the swing pattern
1
Push and hold the SWING/FIX button for at least 4
seconds while the operation is stopped.
blinks.
2
Push the UNIT LOUVER button (left side of the button)
to select a unit.
The unit number changes each time you push the
button.
Unit No. Unit No. Unit No.
1-1 1-2 1-3
No Unit No.
display 1-4
The fan of the selected unit runs, and the louver swings.
3
Push the TIME buttons to select a swing
type.
Swing code
Swing code Movement pattern
Standard swing
0001
(factory default)
0002 Dual swing
0003 Cyclic swing
REQUIREMENT
Do not set "0000".
(The louver may be damaged.)
EN-21
– 11 –
4
Push the button.
5
Push the button to finish the setting.
Standard swing
All four louvers swing simultaneously at the same
angle.
Swing
Dual swing (Recommended for heating)
• Adjoining louvers alternately point horizontally and
downward to heat the room evenly.
• Air blown downward reaches the floor, and air blown
horizontally is spread to circulate heat.
Horizontal
Horizontal
Downward
Downward
Horizontal
Horizontal
Downward
Downward
Cyclic swing (Recommended for cooling)
All four louvers swing at different times like waves.
(2)
(3)
(1)
(4)
(2)
(4)
(1)
(3)
(1)
(2)
(4)
(3)
(2)
(1)
(3)
(4)
Owner's Manual
Setting the louver lock
1
Push and hold the button (right side of
UNIT LOUVER
the button) for at least 4 seconds while running
is stopped.
blinks.
• When no unit number is displayed, all units are
selected.
2
Push the button (left side of the button)
UNIT LOUVER
to select a unit.
The unit number changes each time you push the
button.
Unit No. Unit No. Unit No.
1-1 1-2 1-3
Unit No.
1-4
The fan of the selected unit runs, and the louver
swings.
3
Push the "TEMP. " buttons to display the
number of the louver to fix its direction.
The selected louver swings.
4
Push the TIME buttons to select the
direction of the louver you do not want to swing.
(1) (2) (3)
0001 0002 0003
(4) (5)
0004 0005
* If (4) or (5) is selected, condensation may occur
during cooling.
5
Push the button to confirm the setting.
When the setting is confirmed, the mark lights up.
(To set the louver lock of another unit, repeat from
Step 2. To set another louver lock of the same unit,
repeat from Step 3.)
6
Push the button to finish the setting.
EN-22