Toshiba MCY-MHP0506HT Owner's Manual page 13

1FAN_OM_EHV0000101-01.book Page 12 Thursday, September 13, 2018 5:10 PM
0001 - 0005
(Louver position
Louver No.
code)
* F1 appears in the CODE No. section on the
remote controller. This indicates that the louver 01
shown in the following figure is selected.
Electrical control box
Refrigerant
pipe
Drain pipe
NOTE
Even in louver lock mode, the louver temporarily moves
in the following cases:
• When the air conditioner is stopped
• When heating starts
• When defrosting
• When thermo. off.
Releasing the louver lock
Set "0000" in Step 4 of "Setting the louver lock".
The mark disappears.
* Steps 1 - 3 and 5, 6 of "Setting
SET DATA
the louver lock" also apply to
releasing the lock.
EN-23
Adjusting the horizontal direction
1
Push and hold the and "TEMP.
buttons for at least 4 seconds while running is
stopped.
blinks.
"01" appears in CODE No.
2
Push the button (left side of the button)
UNIT LOUVER
to select a unit.
The unit number changes each time you push the
button.
Unit No. Unit No. Unit No.
1-1 1-2 1-3
No Unit No.
display 1-4
The fan of the selected unit runs, and the louver
swings.
3
Push the "TEMP. " buttons to change
the CODE No. to "45".
4
Push the "TIME "buttons to select a
direction.
Direction SET
Direction setting
DATA
Smudging reduction position
"0000" (reduces ceiling smudging)
(factory default)
Cold draft position
"0002" (Less directly expose your body to
cool air)
5
Push the button to check the settings.
The indicator stops blinking and stays lit, and the
settings are confirmed.
6
Push the button to finish the setting.
* If the cold draft position is selected, the ceiling
smudging reduction effect will be reduced.
0000
4-way cassette type
" When cooling
Point the louver horizontally.
When heating
Point the louver downward.
• The louver automatically closes when running is
stopped.
• In pre-heating mode, the louver points upward. The
swing indication appears on the remote controller
even in pre-heating mode, but the actual swing starts
only after pre-heating is complete.
2-way and 3-way air discharge
The air discharge can be changed to the 2-way or 3-way
type to suit your room shape and style.
For details, contact the dealer where you purchased the
air conditioner.
– 12 –
Owner's Manual
2-way cassette type
When cooling
Point the louver horizontally to send cool air across the
entire room.
When heating
Point the louver downward to send heated air to the floor.
1-way cassette type (SH series)
When cooling
Point the louver horizontally to send cool air across the
entire room.
When heating
Point the louver downward to send heated air to the floor.
• The louver automatically closes when running is
stopped.
• In pre-heating mode, the louver points upward. The
swing indication appears on the remote controller
even in pre-heating mode, but the actual swing starts
only after pre-heating is complete.
EN-24