Starting A New Job (Or Refilling The Material Cup) - Graco 17C810 Operation - Repair - Parts

Starting a New Job
(or Refilling the Material Cup)
1. Engage trigger lock and put prime/spray valve UP to
release pressure.
ti18912a
ti14994a
Strain the Paint
Previously opened paint may contain dried paint or
other debris. To avoid priming problems and tip clogs it
is advisable to strain the paint before using. Paint strain-
ers are available where paint is sold. Stretch a paint
strainer over a clean pail and pour the paint through the
strainer to capture any dried paint and debris before
spraying.
3A2587L
ti16700a
ti14999a
ti26640a

Starting a New Job (or Refilling the Material Cup)

2. Install material cup liner, fill with material, and
thread onto sprayer.
ti15474a
3. To fill sprayer with fluid, disengage trigger lock and
trigger sprayer for 10 seconds. Then release trigger
and put prime/spray valve DOWN to spray position.
ti14995a
ti18913a
4. Reverse spray tip to UNCLOG position. Pull trigger
and release.
ti14777a
5. Put prime/spray valve UP to release pressure. Then
rotate spray tip back to spray position.
NOTE: Failure to perform this operation could result
in poor spray pattern.
ti16700a
ti15551a
ti16716a ti15425a
ti15418a
ti16701a
ti15012a
ti14778a
11