Choosing The Correct Tip; Understanding Tip Number; Selecting Tip Hole Size; Choosing Pressure Control Knob Setting - Graco 17C810 Operation - Repair - Parts

Electric hand-held paint sprayers
Table of Contents

Advertisement

Choosing the Correct Tip

Understanding Tip Number

The last three digits of tip number (i.e.: XXX515) con-
tains information about hole size and fan width on sur-
face when gun is held 12 in. (30.5 cm) from surface
being sprayed.
First digit when doubled = approximate fan width
515 tip has
10 - 12 in.
fan width
Last two digits = tip hole size in thousands of an inch
Example: For a 10 - 12 in. (254 - 305 mm) fan width and
a 0.015 in (0.38 mm) hole size, order part number
XWD515.

Choosing Pressure Control Knob Setting

Recommendations of a starting point for determining the best set point for your sprayer and particular coating are
shown in the table below.
Tip Hole Size
0.011 in. (0.28 mm)
0.015 in. (0.38 mm)
0.017 in. (0.43 mm)
Pressure Control Knob
Setting Number
10
NOTE: Spraying with the 0.011 tip at high pressure settings may cause the motor to overheat. Shut down sprayer
until it cools and then spray at a lower setting.
3A2587L

Selecting Tip Hole Size

HINTS:
515 tip has
a 0.015 in.
hole size
Thinner
Stains
Enamels
0 - 2
3 - 7
Tips come in a variety of hole sizes for spraying a
range of fluids. The sprayer includes a 0.015 in.
(0.38 mm) tip for use in most spraying applications.
Use the table below to determine the range of rec-
ommended tip hole sizes for each fluid type.
Consider coating and surface to be sprayed. Make
sure to use the best tip hole size for the coating and
best fan width for that surface.
Tip hole size controls flow rate - the amount of paint
that comes out of the gun.
As you spray, the tip wears and enlarges. Starting
with a tip hole size smaller than the maximum will
allow you to spray within the rated flow capacity of
the sprayer.
Tips wear with use and abrasive paint and need
periodic replacement.
Do not spray with worn spray tips. Poor spray pat-
tern quality will result.
Coatings
Primers
Interior Paints
4 - 10
4 - 10
Choosing the Correct Tip
Thicker
Exterior Paints
4 - 10
13

Advertisement

Table of Contents
loading

This manual is also suitable for:

16n65916n67316n658

Table of Contents