Overheating Protection; Sprayer Setup - Graco 17C810 Operation - Repair - Parts

Overheating Protection

Overheating Protection
The motor has a built-in feature to protect itself from
overuse. If the motor stops, the thermal switch has
tripped. Do not return sprayer to store. The motor will
operate normally after cooling for 20-30 minutes.
For best results, do not spray more than one cup of
water through the tip while cleaning. If more flushing
is needed, remove the tip from the sprayer.

Sprayer Setup

Use only non-flammable or water-based materials,
or non-flammable paint thinners. Do not use materi-
als which state "FLAMMABLE" on the packaging. For
more information about your material, request Safety
Data Sheets (SDS) from distributor or retailer.
Use oil-based material outdoors or in a well-ventilated
indoor area with a flow of fresh air.
Keep spray area well-ventilated. Keep a good supply
of fresh air moving through the area.
Your sprayer is NOT compatible with harsh cleaners
such as chlorine bleach. Using these cleaners will
cause damage to the sprayer.
This sprayer arrives from the factory with a small
amount of test material in the system. It is important
that you flush this material from the sprayer before
using it for the first time:
1. Fill material cup with water or compatible solvent,
thread onto sprayer and hand tighten.
ti14992a
10
NOTICE
ti18915a
2. Put prime/spray valve to UP position, then hold trig-
ger in for 10 seconds.
ti16700a
3. Put prime/spray valve DOWN to spray position.
ti16701a
4. Reverse spray tip to UNCLOG position and trigger
sprayer into a waste area for 10 seconds.
ti14777a
5. Engage trigger lock and put prime/spray valve UP to
release pressure.
ti14994a
ti18912a
6. Unscrew and remove material cup.
7. Disengage trigger lock, hold sprayer slightly above
material cup, and pull trigger to discharge fluid from
pump.
8. Discard material in cup.
ti14999a
ti15425a
ti15012a
ti15491a
ti16700a
ti14999a
ti18919a
3A2587L