Page 1
Operation ™ High Pressure JetRoller 3A5565B and Extension For spray rolled application of architectural paints and coatings. Not approved for use in explosive atmospheres or hazardous locations. Model 25D229 - High Pressure Jet Roller Model 17U148 - High Pressure Extension 42” 7250 psi (50.0 MPa, 500.0 bar) Maximum Working Pressure Important Safety Instructions Read all warnings and instructions in this...
Check hoses and parts for signs of damage. Replace any damaged hoses or parts. • This system is capable of producing 7250 psi (500 bar, 50 MPa). Use Graco parts or accessories that are rated a minimum of 7250 psi (500 bar, 50 MPa).
Setup WARNING EQUIPMENT MISUSE HAZARD Misuse can cause death or serious injury. • Do not operate the unit when fatigued or under the influence of drugs or alcohol. • Do not exceed the maximum working pressure or temperature rating of the lowest rated system component.
Setup Cleaning Tips/Clearing Clogs clog. Engage trigger lock. Rotate tip 180° back to spray position. NOTE: Clean tip and tip guard at end of each work day. b. Flat tips: Remove tip and clean with a 1. Follow Pressure Relief Procedure. Engage trigger solvent-soaked brush.
Page 5
Setup Part Part Ref. Number Description Ref. Number Description 001 17W475 CLAMP, handle, assem- 012 17V677 KIT, gun, XTR706, XHD523 002 17U833 EXTENSION, roller, fixed 014 246297 NOZZLE, 180 HP spray 003 17W474 CLAMP, knob, assembly 015 166969 GASKET, non-metallic 004* 24W131 ARM, assembly, frame (included in 014) 005* 17B527...
Page 6
ti33935a Part Ref. Number Description 001 17W475 CLAMP, handle, assembly 002 17U833 EXTENSION, roller, fixed 014 246297 NOZZLE, 180 HP spray 015 166969 GASKET, non-metallic (included in 014) 3A5565B...
With the exception of any special, extended, or limited warranty published by Graco, Graco will, for a period of twelve months from the date of sale, repair or replace any part of the equipment determined by Graco to be defective.