Starting A New Job (Or Refilling The Material Cup) - Graco 16N661 Operation - Repair - Parts

Starting a New Job
(or Refilling the Material Cup)
1. Engage trigger lock and put prime/spray valve UP to
release pressure.
ti18912a
ti14994a
2. Install material cup liner, fill with material, and
thread onto sprayer.
ti15474a
3. To fill sprayer with fluid, disengage trigger lock and
trigger sprayer for 10 seconds. Then release trigger
and put prime/spray valve DOWN to spray position.
ti14995a
ti18913a
4. Reverse spray tip to UNCLOG position. Pull trigger
and release.
ti14777a
5. Put prime/spray valve UP to release pressure. Then
rotate spray tip back to spray position.
NOTE: Failure to perform this operation could result
in poor spray pattern.
ti16700a
3A2854G
ti16700a
ti14999a
ti15551a
ti16716a ti15425a
ti15418a
ti16701a
ti15012a
ti14778a

Starting a New Job (or Refilling the Material Cup)

If sprayer fails to prime, try one of the steps
below:
1. Use the Pump Armor storage/startup tool to clean
the inlet valve fitting. See Storage, page 17.
2. Clean air vent holes. See Shutdown and Cleaning,
page 15.
Use a soft brush to clean the black rubber inlet seal.
If air vent holes become clogged, use a paper clip to
clean the holes.
ti19536a
ti17323a
ti17326a
11