Table of Contents
Advertisement
Hard drive
NOTE:
The hard drive spare part kit includes left and right bracket rails, a connector cable, Mylar
cover with tab, and 4 rubber isolators.
Description
1-TB. 5200-rpm
750-GB, 5200-rpm
640-GB, 5400-rpm
500-GB, 7200-rpm
320-GB, 7200-rpm
250-GB, 7200-rpm
Hard Drive Hardware Kit (includes left and right bracket rails, connector cable, Mylar cover with
tab, and 4 rubber isolators)
Before removing the hard drive, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4.
Remove the battery (see
5.
Remove the primary hard drive cover (see
Remove the hard drive:
1.
Disconnect the hard drive cable connector from the system board (1).
2.
Remove the four Phillips PM2.5×3.0 screws (2).
Battery on page
45).
Primary hard drive cover on page
Spare part number
603788-001
603787-001
603785-001
603784-001
603783-001
605606-001
605415-001
46).
Component replacement procedures
47
Advertisement
Table of Contents
