Power Connector Cable - HP Pavilion DV5-2129 Maintenance And Service Manual

4. Disconnect the USB board cable (1) from the system board.
5. Remove the USB board (2) from the alignment clip built into the base enclosure.
6. Remove the USB board and cable.
Reverse this procedure to install the USB board.

Power connector cable

Description
Power connector cable
Before removing the power connector cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
a.
Memory module/wireless module compartment cover (see
b. Hard drive cover (see
c. Keyboard (see
d. Top cover (see
e. Base enclosure bracket (see
Battery on page 49), and then remove the following components:
Hard drive on page
Keyboard on page 64)
Top cover on page 67)
USB board on page
Memory module on page
58)
74)
Component replacement procedures
Spare part number
606890-001
50)
75