Devices - User Option - Honeywell Notifier ID60 Series Operating Manual

2
CLIP protocol
Device Device
Address Type
[U0 Sensor 02 - OPT]
PW1:286 2:283
2
[U0 Sensor 03 - OPT]
PW1:286
Pulse Width Time Periods
OPAL protocol
Device Device
Address Type
[U0 Sensor 04 - OPT]
Value: 049,
Sub-address values (up to 6 values)
Sub-address Values Explained
Sensors: the first value indicates the
sensor status, i.e fire, pre-alarm, etc. used
by the panel. The next values (before the
semi-colon) are internal to the sensor and,
therefore, are of no concern to the user.
Modules: the first value is interpreted by
the panel as an indication of the module's
health status. The next values represent
the status, where appropriate, of inputs
and/or output circuits.
In either case, the last value (after the semi-
colon) shows the status of the internal isolator,
if fitted: 224 = isolator closed, 96 = isolator
open. For devices without an internal
isolator this value = 0.
ID50 Series Panel - Operating Manual

4.12.2 Devices - User Option

The Devices User Option allows the user to observe all
loop devices in turn. Device data is displayed on the bottom
line of the display and the format depends on the
configured protocol (CLIP or OPAL) of the selected device.
To view Devices, from the View Mode menu:
[U0 View] 1:Log
4:Input Events
1 On the numeric keypad, press the '
[U0 Sensor nn - AAA]
PW1:286
2
>: Next
3:285 4:1003 5:0292 <:Exit
2:283 3:285 4:1003
>: Next
026, 000, 000, 000, 000; 224
3 Press the
[U0 Sensor nn - OPT]
Level 050%
Note: Three percentage values are displayed [this is the
For OPAL protocol devices, the device data displayed is
for reference purposes only:
[U0 Sensor 04 - OPT]
SN.: DA1BFCCB Imp: 31 Rev: 026 Avg: 025, 027
4 Press the '
39
2:Devices
5:Disabled
the Devices display. The LCD displays the last-viewed
sensor address:
2:283 3:285 4:1003
Press the ' / ' buttons to scroll through device
2 8
address entries until the desired sensor is displayed.
If the loop has mixed protocol devices the display will
show the approriate device information.
8
: More
>: Next : More
5:0292 <:Exit
: More
Isolator state value
' button to view additional device
6
information. For CLIP protocol devices:
-〉 〉 〉 〉 〉 050% -〉 〉 〉 〉 〉 050%
device's alarm level status, e.g. 100% (default) is
equivalent to alarm]. The value on the left is the current
alarm status level. The other percentage values are
historical; the previous two alarm status percentages
are displayed, the one on the left being the more recent.
' button to return to the View Mode
4
menu.
3:Faults
: More
' button to select
2
>: Next : More
5:0292 <:Exit
>: Next : More
>: Next : More
997-264-000-10, Issue 10
January 2010