Power Fail - Honeywell Notifier ID60 Series Operating Manual

If both the AC and
Battery power fail, the
indicators and LCD are
non-operational.
DISABLEMENT
TEST POWER SUPPLY FAULT
DELAYS ACTIVE
FIRE OUTPUT: FAULT / DISABLED
FIRE OUTPUT ACTIVE SOUNDER: FAULT / DISABLED
PLANT ALARM
POWER
FIRE CONTROL O/P: FAULT / DISABLED
997-264-000-10, Issue 10
January 2010
ID50 Series Panel - Operating Manual
2 If a service contact number has been entered during
A
FAULT
E
For Service Contact ***** ******
Note: Press the MUTE BUZZER pushbutton to silence
3 When the cause of the fault has been cleared, press
Status: NORMAL

3.3.1 Power Fail

1 The loss of a power supply causes the panel to enter
a. Fault condition.
b. Fault number currently displayed.
c. Total number of faults logged.
FAULT
d. Time fault was logged.
EARTH FAULT
e. A text message describing the fault.
SYSTEM FAULT
PRE- ALARM
A
FAULT
E
NO MAINS SUPPLY
A battery fault is shown on the LCD as follows:
FAULT
BATTERIES MISSING
2 If a service contact number has been configured, the
Note: Press the MUTE BUZZER pushbutton to silence
3 When the cause of the fault has been cleared, press
Status: NORMAL
10
panel commissioning, the LCD alternates between the
fault message(s) and the following:
B
01 / 03
the panel's internal buzzer.
the RESET pushbutton.
Sat 01/12/2001
a Power Fail condition. The POWER SUPPLY FAULT
and general FAULT LEDs illuminate and the internal
buzzer operates. The LCD displays:
B
01 / 02
01 / 02
LCD alternates between the power fault message and
the service contact number.
the panel's internal buzzer.
the RESET pushbutton.
Sat 01/12/2001
C D
14:55
00:00:00
C D
14:55
14:55
00:00:00