Table of Contents
Advertisement
Audio/USB board
Description
Audio/USB board (includes cable)
Before removing the audio/USB board, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4.
Remove the battery cover and battery (see
5.
Remove the memory module/wireless module compartment cover (see
on page
6.
Remove the top cover (see
Remove the audio/USB board:
1.
Disconnect the speaker cable (1) from the audio/USB board.
2.
Release the grounding tape (2) that secures the audio/USB board cable to the base enclosure.
3.
Release the ZIF connector to which the audio/USB board cable is attached, and then disconnect
the cable (3) from the system board.
4.
Remove the Phillips PM2.5×4.0 screw (4) that secures the audio/USB board to the base
enclosure.
5.
Remove the audio/USB board (5) and cable.
Reverse this procedure to install the audio/USB board and cable.
41).
Top cover on page
Battery on page
34).
50).
Component replacement procedures
Spare part number
608379-001
WLAN module
55
Advertisement
Table of Contents
