Table of Contents
Advertisement
GAS CONNECTION
WARNING: This appliance requires an operating pressure of
2.8-3.0 kPa. A suitable LPG regulator that complies with the
requirements of SANS 1237 must be used.
WARNING: Flexible hose: Not supplied. Any hose that is used
to connect the stove to the gas system shall comply with SANS
1156-2 or BS 3212.
WARNING: Regulator: Not supplied. A 2.8-3.0 kPa LPG gas
regulator which complies with SANS 1237 must be used.
WARNING: Before starting any work related with gas installation,
turn off gas supply. Risk of explosion.
WARNING: Please operate your oven in dry atmosphere.
1. Fit the clamp to the hose. Push one of the hose until it goes
to the end of the pipe.
2. For the sealing control; ensure that the buttons in the control
panel are closed, but the gas cylinder is open. Apply some soap
bubbles to the connection. If there is gas leakage, there will be
foaming in the soaped area.
3. The oven should be using a well ventilation place and should
be install on flat ground.
4. Re-inspect the gas connection.
5. When placing your oven to its location, ensure that it is at the
counter level. Bring it to the counter level by adjusting the feet
if necessary.
6. Do not make gas hose and electrical cable of your oven go
through theheated areas, especially through the rear side of the
oven. Do not move gas connected oven. Since the forcing shall
loosen the hose, gas leakage may occur.
7. Please use flexible hose for gas connection.
20
Advertisement
Table of Contents
