Table of Contents
Advertisement
7. WARNING: To avoid electric shock, ensure
that the device circuit is open before changing
the lamp.
8. WARNING: Cut off all supply circuit connections
before accessing the terminals.
9. WARNING: If the surface is cracked, turn off
the appliance to avoid risk of electric shock.
10. Do not use cut or damaged cords or extension
cords other than the original cord.
11. Make sure that there is no liquid or humidity
in the outlet where the product plug is installed.
12. The rear surface of the oven also heats up
when the oven is operated. Electrical connections
shall not touch the rear surface, otherwise the
connections may be damaged.
13. Do not tighten the connecting cables to the
oven door and do not run them over hot surfaces.
If the cord melts, this may cause the oven to short
circuit and even a fire.
14. Unplug
maintenance, cleaning and repair.
15. If the power supply cable is damaged, it must
be replaced by its manufacturer or authorized
technical service or any other personnel qualified
at the same level, in order to avoid any dangerous
situation.
the
unit
13
during
installation,
Advertisement
Table of Contents
