Chevrolet 2011 Corvette Coupe Owner's Manual page 375

battery. It goes to a heavy,
unpainted metal engine part or
to a remote negative ( ) terminal
on the vehicle with the dead
battery.
9. Connect the other end of the
negative ( ) cable at least 45 cm
(18 inches) away from the dead
battery, but not near engine
parts that move. The electrical
connection is just as good there,
and the chance of sparks getting
back to the battery is much less.
Your vehicle has a remote
negative ( ) terminal for this
purpose.
10. Now start the vehicle with the
good battery and run the
engine for a while.
11. Try to start the vehicle that
had the dead battery. If it will
not start after a few tries, it
probably needs service.
If the jumper cables are
connected or removed in the
wrong order, electrical shorting
may occur and damage the
vehicle. The repairs would not be
covered by the vehicle warranty.
Always connect and remove the
jumper cables in the correct
order, making sure that the
cables do not touch each other
or other metal.
Vehicle Care
Jumper Cable Removal
A. Heavy, Unpainted Metal Engine
Part or Remote Negative ( )
Terminal
B. Good Battery or Remote
Positive (+) and Negative ( )
Terminals
C. Dead Battery or Remote
Positive (+) Terminal
10-85