Chevrolet 2011 Corvette Coupe Owner's Manual page 151

Battery Voltage: This display
shows the current battery voltage.
Press the gauges button again to
display the battery voltage, such as:
BATTERY VOLTAGE
13.5 VOLTS
Tire Pressure: This display shows
the tire pressure for each tire.
Press the gauges button again to
display the tire pressure for the front
tires, such as:
FRONT TIRE PRESSURES
L 234 kPa R 228 kPa or
FRONT TIRE PRESSURES
L 34 PSI R 33 PSI
Press the gauges button again to
display the tire pressure for the rear
tires, such as:
REAR TIRE PRESSURES
L 234 kPa R 228 kPa or
REAR TIRE PRESSURES
L 34 PSI R 33 PSI
TRIP Button
The TRIP button displays the
odometer, trip distance, elapsed
time, average speed, and oil life
remaining information.
Odometer: The odometer shows
how far your vehicle has been
driven in either kilometers or miles.
Press the TRIP button to display
odometer readings, such as:
ODOMETER 20008 km or
ODOMETER 12345 MI
You can also display the odometer
by turning on the parking lamps.
Trip Odometers: There are two trip
odometers. Press the TRIP button
to display TRIP ODOMETER A
readings and press the button again
to display TRIP ODOMETER B
readings, such as:
TRIP ODOMETER A 209.9 km or
TRIP ODOMETER A 130.5 MI
TRIP ODOMETER B 483.5 km or
TRIP ODOMETER B 300.5 MI
Instruments and Controls
Both of the trip odometers can
be used simultaneously. The trip
odometers can be reset by pressing
the RESET button on the DIC.
There is also a miles since last
ignition feature that displays the
number of kilometers (miles) driven
since you last started the vehicle.
Press and hold the RESET button
for three seconds, then release it.
The kilometers (miles) since the last
ignition cycle will be set into the trip
odometer.
Elapsed Timer: Press the
TRIP button until ELAPSED
TIMER is displayed, such as
ELAPSED TIMER .00.
When the ignition is in on, the DIC
can be used as a stopwatch. The
display can show hours, minutes,
and seconds. The elapsed time
indicator will record up to 23 hours,
59 minutes, and 59 seconds, then
it will reset to zero and continue
counting. The display appears as
ELAPSED TIMER .00 in the elapsed
time function.
5-29