Chevrolet 2011 Corvette Coupe Owner's Manual page 185

To program a name, use the
following procedure:
1. Enter the PERSONAL OPTIONS
menu and select the driver
number (1 or 2) that you would
like to program by following the
instructions listed previously
under Entering the Personal
Options Menu .
2. Press the OPTION button until
the PERSONALIZE NAME
option appears on the display.
3. Select YES under
PERSONALIZE NAME by
pressing the RESET button.
4. Press the OPTION button and
a cursor will display where
you can insert a letter.
5. Press the OPTION button
again until the letter you want
is displayed. To scroll through
the letters faster and without
a beeping noise, keep the
OPTIONS button depressed.
There are alpha/numeric
characters and a blank space
available.
6. Press the RESET button to
select the letter of your choice
and proceed on to the next
space to the right.
If you make a mistake and would
like to clear or replace a letter,
perform the following steps:
6.1. Press the RESET button to
reach the letter you would
like to change.
6.2. Press the OPTION button
to scroll through the letter
choices.
6.3. Press the RESET button
to select the letter and
proceed on to the next
space to the right.
7. Repeat Steps 5 and 6 until the
name or greeting you want is
complete. After the name or
Instruments and Controls
greeting is complete, keep
pressing the RESET button until
the display turns blank and
exits out of this option. You can
program up to 20 characters.
If you choose NO, this option will
turn off.
If a customized name or greeting
is not programmed, the DIC display
will show Driver 1 or Driver 2
to correspond with either the
number on the back of the RKE
transmitter (1 or 2) being used or to
the memory button (1 or 2) that is
pressed.
PERSONALIZE NAME is the
last option available to program in
the PERSONAL OPTIONS menu.
Pressing the OPTION button after
this setting will exit you from the
PERSONAL OPTIONS menu.
The last item you were in prior to
entering PERSONAL OPTIONS will
then display on the DIC.
5-63