Powering The Mr55-Hw With Meraki Ac Adapter; Powering The Mr55-Hw With Meraki 802.3At Power Over Ethernet Injector - Cisco Meraki MR55-HW Hardware Installation Manual

4.2.2.1 Powering the MR55-HW with the Meraki AC Adapter (sold separately)
1. Plug the power cord into the MR55-HW and the other end into a wall outlet.
2. Plug an Ethernet cable that is connected to an active Ethernet connection into the Eth0 port on
the MR55-HW.
4.2.2.2 Powering the MR55-HW with the Meraki 802.3at Power over Ethernet Injector (sold
separately)
1. Plug the power cord into the PoE Injector and the other end into wall power.
2. Plug an Ethernet cable that is connected to an active Ethernet connection into the "IN" port on
the injector.
3. Route Ethernet cable from the "OUT" port on the injector to the Eth0 port in the cable bay of the
MR55-HW.
18