Powering The Mr46E-Hw With Meraki Ac Adapter - Cisco MERAKI MR46E-HW Hardware Installation Manual

Powering the MR46E-HW with the Meraki AC Adapter (sold separately)
4.2.2.1
Plug the power cord into the MR46E-HW and the other end into a wall outlet.
1.
Plug an Ethernet cable that is connected to an active Ethernet connection into the Eth0 port on
2.
the MR46E-HW.
Powering the M410-HW with the Meraki 802.3at Power over Ethernet Injector (sold
4.2.2.2
separately)
Plug the power cord into the PoE Injector and the other end into wall power.
1.
Plug an Ethernet cable that is connected to an active Ethernet connection into the "IN" port on the
2.
injector.
Route Ethernet cable from the "OUT" port on the injector to the Eth0 port in the cable bay of the
3.
MR46E-HW.
18