Recommandations Importantes - Peg-Perego IGOD0534 Use And Care Manual

Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 15
Picture A shows the grille fitted correctly
81 • Secure the grille with the three screws.
82 • Place the windshield on the hood hooking the
three central tabs.
83 • Fit the windscreen of the vehicle with screws
84 • Remove the protectors from the rear axle.
85 • Insert the axle into the rear of the vehicle, as
shown in the figure.
86 • Position the driver in the inside of one of the
two larger wheels.
87 • Slide the wheel onto the axle with the driver
towards the vehicle.
88 • Slide a washer onto the axle.
89 • Fasten the wheel, tightening one of the four nuts
supplied with the spanner provided.
• Repeat the fitting operations for the other rear
wheel. Important: carry out the operations while
holding the axle still on the opposite side with
the help of the second spanner provided.
90 • Remove the protectors from the front axles.
91 • Slide a washer onto the axle.
92 • Slide one of the remaining wheels (narrower
than the rear wheels) onto the axle.
93 • Slide a washer onto the axle.
94 • Fasten the wheel, tightening one of the two
remaining bolts with the spanner provided.
• Repeat the fitting operations for the front wheel
on the other side.
95 • Snap fit the four hub covers onto the wheels.
FEATURES AND USE OF THE VEHICLE
96 • RADIO - Remove the two screws as shown in
the figure to extract the radio and insert the
batteries.
97 • Use a tool to lever the upper part of the radio
front panel and extract it.
98 • Release the screw on the battery compartment
cover.
99 • Insert two AA 1.5V batteries with the polarities
as indicated. Close the battery compartment
cover. Important: always tighten the screw.
100 • Insert the antenna and the radio into the
housing on the dashboard.
101 • Radio functions:
• A - Socket for an MP3 reader jack.
IMPORTANT!: Connect the MP3 reader (not
included) to the vehicle radio using a cable
NO longer than 150 cm - 59".
• B - Radio station selector.
• C - On/Off buttons.
• D - Radio On indicator light.
• E - Volume control knob.
• F - Digital clock adjustment buttons.
102 • Driving cab features:
• A - Steering wheel.
• B - Fully functional radio (see fig 101).
• C - Passenger handle.
• D - Accelerator/electrical brake pedal
• E - Gear lever (see fig 103 - 104).
• F - Drinks holder (see fig 105).
• G - MP3 player storage compartment.
103 • GEAR LEVER: when supplied the vehicle speed
is limited to first gear (1 - see figure). It also
has a reverse (R), and a second gear (2)
recommended only for expert drivers. To
enable the second gear, unscrew the red stop
on the gear lever.
104 • Rotate the stop 90°, as shown in the figure,
and fix in position with the screw. Now by
pulling back the gear lever the vehicle can run
in second gear.
105 • DRINKS HOLDER - There are two drinks
holders for cans or bottles.
106 • REAR BOX and SUSPENSION - The rear of
the vehicle has a spacious cargo box and real
functional suspension on the wheels.
107 • WHEELS with RUBBER STRIPS Red Line
Nitrile Traction™ - The wheels are fitted with
a rubber strip for better grip on all surfaces,
silent performance and greater driving
comfort.
108 • SAFETY BELT - To fasten the safety belt, insert
the end of the longer belt section into the
buckle on the shorter belt section, pushing the
two parts together.
109 • To release the safety belt, press the buckle
button and at the same time separate the two
elements.
110 • To change the length of the safety belt, move
the adjuster as shown in the figure.
111 • ACCESSORY: trailer to attach to the vehicle
(sold separately).
REPLACING THE BATTERY
PLEASE NOTE: THE PICTURES OF THE BATTERIES
ARE FOR ILLUSTRATIVE PURPOSES ONLY. YOUR
BATTERY MAY BE DIFFERENT FROM THE MODEL
SHOWN. THIS DOES NOT AFFECT THE
REPLACEMENT AND CHARGING PROCEDURES
DESCRIBED.
112 • Release the passenger seat safety screw and
lift the seat.
113 • Unscrew the knobs and remove the seat.
114 • Unscrew the two seat base screws. Disconnect
the battery and electrical system plugs.
115 • Extract the seat base and pull out the plugs.
116 • Replace the battery.
• Replace the seat base after passing the plugs
through the holes. Connect the plugs and
replace the seat.
117 • WARNING: always replace and tighten all the
knobs and screws.
CHARGING THE BATTERY
WARNING: BATTERY CHARGING AND ANY
OTHER WORK ON THE ELECTRICAL SYSTEM
MUST BE CARRIED OUT BY ADULTS.
THE BATTERY CAN ALSO BE CHARGED
WITHOUT REMOVING IT FROM THE TOY.
118 • Disconnect the electrical system plug A from
the battery plug B, pushing on the sides of the
plugs to release them.
119 • Plug the battery charger into a domestic
power outlet following the instructions
enclosed with it. Connect plug B to the
battery charger plug C.
120 • When charging is complete, disconnect the
battery charger from the domestic power
supply and then disconnect plug C from plug
B.
121 • Fully insert plug B into plug A until it clicks
into position.
• WARNING: when the charging operations are
complete, always replace and tighten all the
knobs and screws.
122 • The battery can also be charged outside the
vehicle. This means that if you have a spare
battery, the child can continue to use the toy.
FRANÇAIS
®
PEG PEREGO
vous remercie d'avoir
choisi ce produit. Depuis plus de 60 ans,
PEG PEREGO accompagne les promenades
des enfants. Dès leur naissance, avec les
landaus puis avec les poussettes et plus
tard, avec les jouets à pédales et à
batterie.
Découvrez sur notre site la gamme
complète des produits, les nouveautés et
d'autres renseignements sur le monde Peg
Perego.
www.pegperego.com
Peg Perego S.p.A. est une entreprise disposant
d'un système de management de la qualité certifié
conforme à la norme ISO 9001 par
TÜV Italia Srl. Cette certification garantit aux
clients et aux consommateurs une transparence et
une confiance en l'entreprise et son mode de
fonctionnement.
RECOMMANDATIONS
IMPORTANTES
Lisez attentivement ce manuel d'instructions pour
vous familiariser avec le modèle et apprendre à votre
enfant à le conduire de façon correcte, amusante et
en toute sécurité. Conserver ensuite ce manuel pour
pouvoir vous y référer à l'avenir.
Si le produit est confié à des tiers, assurez-vous qu'il
soit accompagné du manuel d'instructions.
Avant d'utiliser le véhicule pour la première fois,
mettez en charge la batterie pendant 18 heures.
Ne pas appliquer cette règle pourrait être à l'origine
de dommages irréversibles à la batterie.
• Âge 6+
• Poids maximal autorisé 60 kg
• Véhicule à 2 places
• 1 Batterie rechargeable de 24V 12Ah scellée au
plomb
• 2 roues motrices
• 2 moteurs de 340 W
• Vitesse en première 5 km/h
• Vitesse en seconde 10 km/h
• Vitesse en marche arrière 5 km/h
Ne pas dépasser le poids maximal autorisé de 60 kg.
Cette limite s'applique aussi bien aux conducteurs
qu'à l'éventuel chargement.
Peg Perego se réserve le droit d'apporter, à tout
moment, des modifications aux modèles et aux
données figurant dans ce livret, pour des raisons de
caractère technique ou de management.

Advertisement

Table of Contents
loading

Table of Contents