Recommandations Importantes - Peg-Perego Ducati Desmosedici Evo IGED0924 Use And Care Manual

6 volt
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 7
threaded pin from above.
23 • Click the front mudguard onto the fork. Make
sure that it is the right way around, as shown in
the figure.
24 • Press the other rims into the remaining wheel,
making sure that the reference pin is fully
interlocked.
25 • Insert a large stud into the red press-stud, as
shown in the diagram. Position the front axle on
the press-stud and secure the stud by using a
hammer.
26 • Assemble the front wheel inserting it into the
prong, following the direction of the tread. Insert
the pin.
27 • Position the press-stud and turn the toy keeping
the press-stud underneath it.
• Insert the stud into the black press-stud and
secure the wheel, as shown in the figure.
28 • Connect the 2 connectors to the handlebar.
29 • Insert the handlebars in the fork unit, until it fits
perfectly into place.
30 • Tighten the 3 screws that hold the handlebars in
place.
31 • Put the appropriate hand guard on the right-hand
side of the handlebars ("DX" is written inside the
right-hand side piece and "SX" is written inside
the left one). Secure it with the screw provided.
Repeat with the other hand guard on the other
side.
32 • Click on the right grip (make sure the writing is
facing the right way). Repeat for the other grip.
33 • Fit the windshield. Insert the 2 front tabs and
click in the 2 clips.
34 • Fasten the 2 windshield screws.
35 • Apply the corresponding sticker (see sticker
sheet) before you assemble the headlight. Snap
the 4 hooks of the headlight in place on the front
plate.
36 • Remove the safety wing screw located in the
battery compartment: lights and sounds will
activate automatically.
WARNING: keep the wing screw for future use.
37 • Insert the front part of the saddle in the
bodywork (1), then pull it down (2).
38 • Push the locking clip all the way down into the
hole at the rear of the saddle.
39 • Turn the locking clip to position B to secure the
saddle. The vehicle is ready for use.
FEATURES AND USE OF THE VEHICLE
40 • With both hands on the handlebars, press the
accelerator pedal with your foot. When the pedal
is released, the electric brake is automatically
activated.
41 • A - melody activating button
B - horn activating button
C - battery charge indicator
D - MP3 input
E - START button
WARNING: lights and sounds deactivate after 3
minutes if the vehicle remains inactive. Press
START or the accelerator to reactivate them.
WARNING: if the vehicle is not used for a long
time, insert the previously stored wing screw
back in place.
CHARGING THE BATTERY
WARNING: BATTERY CHARGING AND ANY
OTHER WORK ON THE ELECTRICAL SYSTEM
MUST BE CARRIED OUT BY ADULTS.
42 • Turn the locking clip to position A to release the
saddle. Remove the saddle.
43 • Connect the battery charger to a socket (1) and
insert the jack into its housing (2).
44 • Once charged, put the saddle back into place and
turn the fastening pin to position B.
How to use the battery charger
WARNING
1 • Insert only lead acid batteries supplied by PEG
PEREGO.
2 • Do not use with non-rechargeable batteries.
Risk of explosion.
3 • For adult use only. It is not a toy. This
appliance is not intended for use by infirm
persons unless they are being adequately
supervised by a responsible person to ensure
that they can use the appliance safely.
4 • Do not use with damaged sheathing, cable or
connector.
5 • Charge the battery only in a well ventilated area.
6 • Do not remove the plug by pulling on the cable.
7 • Do not drag the vehicle along on its wheels by
pulling the battery charger's cable.
8 • Avoid overheating the cable by covering it and
do not rest it on hot surfaces.
9 • Be aware of how the output cable is wound to
prevent damaging it.
10 • Should the battery charger be damaged, do not
use it until it is fully repaired.
11 • The product contains some elements that are
considered harmful to the environment. Disposal
of these elements or of the entire product at the
end of its life should be in accordance with the
regulations in force in the country where it is
used.
12 • Before using the battery charger make sure that
it is fitted with the specific plug for the country
in which it is going to be used.
13 • Children should not play with the battery
charger as IT IS NOT A TOY.
LED INDICATORS
Peg Perego Battery NOT connected
•STEADY LIGHT: battery charger is operating when
plugged into the power outlet, ready for charging.
Peg Perego Battery connected
•STEADY LIGHT: battery charged
•FLASHING LIGHT: battery loading
CHARGING THE BATTERIES
WARNING! Before using the toy, charge
the battery for at least 18 hours.
A) Plug the battery charger into a power outlet that
complies with the specifications on its label
B) Connect the battery charger's jack to the socket
in the battery compartment.
C) Your battery charger is provided with an LED
indicator which means that:
1) When plugging in the charger as described in A)
with no battery connected, the LED will
light up to indicate that the device is working
correctly.
2) Connect the jack as described in section B). If
everything is connected correctly and the
battery is flat, the LED will start blinking,
indicating that it is charging. Wait until the
battery is fully charged.
3) When the battery is fully charged, the LED will
stop blinking. A steady LED indicates that the
battery is now fully charged.
4) If the battery is already charged, the LED will be
steady. If during the next use, the battery doesn't
last long, contact the customer service to verify
whether the battery and battery charger are
working properly.
D) Once the battery is charged and the LED is
steady, disconnect the battery charger from the
socket and then remove the jack. The toy is now
ready for use.
The battery charger is fitted with a safety device
which means that in the event of overheating or a
short circuit of the battery, a protection system will
intervene to prevent current peaks, which could
damage the battery charger.
In this case unplug the battery charger
from the power outlet, remove the cause
of the short circuit and reconnect
everything as described in sections A) to
C).
FRANÇAIS
®
PEG PEREGO
vous remercie d'avoir
choisi ce produit. Depuis plus de 70 ans,
PEG PEREGO accompagne les promenades
des enfants. Dès leur naissance, avec les
landaus puis avec les poussettes et plus
tard, avec les jouets à pédales et à
batterie.
Découvrez sur notre site la gamme
complète des produits, les nouveautés et
d'autres renseignements sur le monde Peg
Perego.
www.pegperego.com
Peg Perego S.p.A. est une entreprise disposant
d'un système de management de la qualité certifié
conforme à la norme ISO 9001 par TÜV Italia Srl.
Cette certification garantit aux clients et aux
consommateurs une transparence et une confiance en
l'entreprise et son mode de fonctionnement.
RECOMMANDATIONS
IMPORTANTES
Lisez attentivement ce manuel d'instructions pour
vous familiariser avec le modèle et apprendre à votre
enfant à le conduire de façon correcte, amusante et
en toute sécurité. Conserver ensuite ce manuel pour
pouvoir vous y référer à l'avenir.
Si le produit est confié à des tiers, assurez-vous qu'il
soit accompagné du manuel d'instructions.
Avant d'utiliser le véhicule pour la première fois,
mettez en charge la batterie pendant 18 heures.
Ne pas appliquer cette règle pourrait être à l'origine
de dommages irréversibles à la batterie.
• Âge 2+
• Poids maximal autorisé 25 kg
• Véhicule à 1 place
• 1 Batterie rechargeable de 6 V 4,5 Ah scellée au plomb
• 1 roue motrice
• 1 moteur de 50 W
• Vitesse en première 3,9 km/h
Ne pas dépasser le poids maximal autorisé de 25 kg.
Cette limite s'applique aussi bien aux conducteurs
qu'à l'éventuel chargement.
Peg Perego se réserve le droit d'apporter, à tout
moment, des modifications aux modèles et aux
données figurant dans ce livret, pour des raisons de
caractère technique ou de management.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Flower princess iged0923

Table of Contents