N
ETWORK
LAN
Figure 28: WPS-Enter a PIN from my access point
The default PIN code of the Router can be found on its label, or in
N
:
OTE
the WPS configuration screen, as shown in
Then the new device successfully connected to the network.
The WPS LED on the Router will turn on green for five minutes when
N
:
OTE
a device has been successfully added to the network.
The WPS function cannot be configured if the wireless function of the
N
:
OTE
Router is disabled. Make sure the wireless function is enabled before
configuring WPS.
There are three submenus under the Network menu (shown in
WAN, MAC Clone and LAN. Click any of them to configure the
corresponding function.
Figure 29: The Network Menu
Choose menu "Network-> LAN", you can configure the IP parameters of
the LAN on the screen as below.
– 48 –
| Configuring the Router
C
4
HAPTER
Figure
23.
Figure
Network
29):