Table of Contents
Advertisement
Chapter 2 Getting Started — Removing/attaching the projection lens
Removing/attaching the projection lens
Attaching and removing method of the projection lens are same for both standard zoom lenses and optional accessories.
Move the projection lens to the home position before replacing or removing the projection lens. (x page 59)
Attention
f Replace the projection lens after turning off the power of the projector.
f Do not touch the lens signal receiver. Dust or dirt may cause defective contact.
f Do not touch the surface of the projection lens with your bare hands.
f Before attaching the projection lens, remove the lens cover attached to the projection lens.
f In case of the ultra short focus zoom lens (Model No.: ET-DLE085), attachment/removal procedures of the Lens Mount Cover are different.
Refer to the user manual supplied with ET-DLE085 for details.
Removing the projection lens
Remove the projection lens using the following procedure.
(i)
Fig. 1
1)
Turn the Lens Mount Cover counterclockwise and remove. (Fig. 1)
2)
While keep pressing the lens release button, turn the projection lens counterclockwise to the end and
remove. (Fig. 2)
Attention
f Store the removed projection lens where it will be free from vibration and impact.
Lens Mount Cover
(ii)
(iii)
(ii)
(i)
Lens release button
Fig. 2
Projection lens
ENGLISH - 47
Advertisement
Table of Contents
