Table of Contents
Advertisement
Initial setting (installation setting)
Set [PROJECTION METHOD] and [COOLING CONDITION] depending on the installation mode. Refer to "Installation mode" (x page 32)
for details.
Set [HIGH ALTITUDE MODE] to [ON] when using the projector at high altitudes between 1 400 m (4 593') and 2 700 m (8 858') above sea
level.
After completed the initial setting, you can change the settings of each item from the [PROJECTOR SETUP] menu.
1)
Press as to select an item.
2)
Press qw to switch the setting.
3)
Press the <ENTER> button to proceed to the initial setting.
Initial setting (stand by mode)
Set the operation mode during the standby. The default setting is [NORMAL], which allows you to use the network function during the standby.
To keep power consumption low during the standby, set this function to [ECO]. After completed the initial setting, you can change the setting
from the [PROJECTOR SETUP] menu → [STANDBY MODE].
1)
Press qw to switch the setting.
2)
Press the <ENTER> button to proceed to the initial setting.
Note
f The above initial setting screen is displayed when the projector is switched on for the first time after purchase. If [ALL USER DATA] is
executed from the [PROJECTOR SETUP] menu → [INITIALIZE], the [STANDBY MODE] item set before execution is displayed.
Chapter 1 Preparation — Start-up display
INITIAL SETTING
PROJECTION METHOD
When PROJECTION METHOD is changed, confirm that
COOLING CONDITION is set correctly.
COOLING CONDITION
It may shorten the life of the lamp and projector if used
in incorrect setting.
HIGH ALTITUDE MODE
Switch to HIGH ALTITUDE MODE "ON" if over 1400m
(4593Ft).
MENU SELECT
SET
ENTER
INITIAL SETTING
STANDBY MODE
When set to ECO, network functions and SERIAL OUT
terminal, and some RS-232C commands are not
available during standby.
CHANGE
SET
ENTER
2/4
FRONT/FLOOR
AUTO
OFF
CHANGE
3/4
NORMAL
ENGLISH - 23
Advertisement
Table of Contents
