Table of Contents
Advertisement
[2]
[3]
[USER]
Adjusting desired correction amount
1)
Press as to select [DYNAMIC IRIS].
2)
Press qw or the <ENTER> button.
f The [DYNAMIC IRIS] individual adjustment screen is displayed.
3)
Press qw to select [USER].
4)
Press the <ENTER> button.
f The [DYNAMIC IRIS] screen is displayed.
5)
Press as to select [AUTO IRIS], [MANUAL IRIS], or [DYNAMIC GAMMA].
6)
Press qw to adjust the correction amount.
[AUTO IRIS]
(Automatic adjustment of
aperture)
[MANUAL IRIS]
(Fixed adjustment of aperture)
[DYNAMIC GAMMA]
(Adjustment of signal
compensation)
Note
f When [DYNAMIC GAMMA] is set to [3], the contrast will be maximized.
f Brightness control and dynamic iris operate simultaneously, but the iris is fully open and does not operate while a brightness measurement
is performed.
f If [DLP Link] is set to [ON], [DYNAMIC IRIS] is fixed to [OFF] while 3D images are displayed.
[SYSTEM SELECTOR]
The projector will automatically detect the input signal, but you can set the system method manually when an unstable signal is input. Set the
system method matching the input signal.
1)
Press as to select [SYSTEM SELECTOR].
2)
Press the <ENTER> button.
3)
Press as to select a system format.
f If inputting signals via the <SDI IN> terminal connection, select the system method by pressing asqw. (Only for PT-DZ870E)
f Available system formats vary depending on the input signal.
Terminal
<VIDEO IN> terminal, <G/
Y>/<B/P
/C> terminals
B
<RGB 1 IN> terminal, <RGB 2
IN> terminal
<DVI-D IN> terminal
76 - ENGLISH
Chapter 4 Settings — [PICTURE] menu
Moderately corrects aperture and signal.
Strongly corrects aperture and signal.
Set any desired correction.
Refer to "Adjusting desired correction amount" (x page 76) for details.
Item
[OFF]
[1] - [255]
[OFF]
[1] - [255]
[OFF]
[1]
[2]
[3]
Select [AUTO], [NTSC], [NTSC4.43], [PAL], [PAL-M], [PAL-N], [SECAM], or [PAL60].
Set it to [AUTO] normally. (Setting [AUTO] will automatically select [NTSC], [NTSC4.43], [PAL],
[PAL-M], [PAL-N], [SECAM], or [PAL60].)
Switch the setting to the signal method for the TV used.
480i, 576i, or 576p signal
VGA60 or 480p signal
Other movie-based signals
480i, 576i, 480p, or 576p
signal
Other movie-based signals
Adjustment
No correction.
Allows you to set in increments of 1. The larger the value, the
stronger the correction.
No correction.
Allows you to set in increments of 1. The larger the value, the
stronger the correction.
No correction.
Slightly compensates the signal.
Moderately compensates the signal.
Strongly compensates the signal.
System format
Select [RGB] or [YC
C
].
B
R
Select from [VGA60], [480p YC
Select [RGB] or [YP
P
].
B
R
Select [RGB] or [YC
C
].
B
R
Select [RGB] or [YP
P
].
B
R
C
], or [480p RGB].
B
R
Advertisement
Table of Contents
