Adjusting The Projected Image - BenQ W1700 User Manual

Adjusting the projected image

Adjusting the projection angle
If the projector is not placed on a flat surface or the
screen and the projector are not perpendicular to
each other, the projected image becomes trapezoidal.
You can screw the adjuster feet to fine-tune the
horizontal angle.
To retract the feet, screw the adjuster feet in a
reverse direction.
Do not look into the lens while the lamp is on. The strong light from the lamp may cause damage to your eyes.
Auto-adjusting the image
In some cases, you may need to optimize the picture quality. To do this, go to the DISPLAY > PC
Tuning menu and select Auto. Within 3 seconds, the built-in Intelligent Auto Adjustment function will
re-adjust the values of Frequency and Clock to provide the best picture quality.
The current source information will be displayed in the corner of the screen for 3 seconds.
This function is only available when PC signal (analog RGB) is selected.
Fine-tuning the image size and clarity
1. Adjust the projected image to the size that you
need using the zoom ring.
Correcting keystone
Keystoning refers to the situation where the projected image becomes a trapezoid due to angled
projection.
• To automatically correct this:
1. Press / on the projector or
2. After the Keystone correction page appears, press and hold the MODE key on the projector for
2 seconds to automatically correct the keystoning problem.
• To manually correct this:
1. Press / on the projector or
14 Positioning your projector
2. Sharpen the image by rotating the focus ring.
/ / on the remote control.
/ / on the remote control.