Networking - Lexmark MX417 Series User Manual

Additional printer setup

Networking

Notes:
•
Purchase a MarkNet N8350 wireless network adapter for MX510de, MX511de, and MX511dhe printer
models or MarkNet N8352 wireless network adapter for MX410de printer model before setting up the
printer on a wireless network. For information on installing the wireless network adapter, see the setup
sheet that came with the adapter.
•
A Service Set Identifier (SSID) is a name assigned to a wireless network. Wired Equivalent Privacy (WEP),
Wi-Fi Protected Access (WPA), and WPA2 are types of security used on a network.
Preparing to set up the printer on an Ethernet network
To configure your printer to connect to an Ethernet network, organize the following information before you
begin:
Note: If your network automatically assigns IP addresses to computers and printers, continue on to installing
the printer.
•
A valid, unique IP address for the printer to use on the network
•
The network gateway
•
The network mask
•
A nickname for the printer (optional)
Note: A printer nickname can make it easier for you to identify your printer on the network. You can
choose to use the default printer nickname, or assign a name that is easier for you to remember.
You will need an Ethernet cable to connect the printer to the network and an available port where the printer
can physically connect to the network. Use a new network cable when possible to avoid potential problems
caused by a damaged cable.
Preparing to set up the printer on a wireless network
Notes:
•
Make sure your wireless network adapter is installed in your printer and working properly. For more
information, see the instruction sheet that came with the wireless network adapter.
•
Make sure your access point (wireless router) is turned on and is working properly.
Make sure you have the following information before setting up the printer on a wireless network:
•
SSID—The SSID is also referred to as the network name.
•
Wireless Mode (or Network Mode)—The mode is either infrastructure or ad hoc.
•
Channel (for ad hoc networks)—The channel defaults to automatic for infrastructure networks.
Some ad hoc networks will also require the automatic setting. Check with your system support person if
you are not sure which channel to select.
47