Lexmark MX417 Series User Manual page 243

Troubleshooting
32.28
32.31
32.34
32.37
For more information, see
Note: If you do not have a replacement cartridge, then see the "Ordering supplies" section or go to
www.lexmark.com.
Replace unsupported imaging unit [32.xy]
Remove the imaging unit, and then install a supported one to clear the message and continue printing. For
more information, see the instruction sheet that came with the supply.
This error can also be caused by installing a genuine Lexmark imaging unit, such as a MICR unit, that is not
intended to be used in this product.
The following error codes indicate that a non‑genuine Lexmark
32.14
32.17
32.20
32.23
32.26
32.29
32.32
32.35
8
32.3
For more information, see
Note: If you do not have a replacement imaging unit, then see the "Ordering supplies" section or visit
www.lexmark.com.
Restore held jobs?
Try one or more of the following:
•
From the printer control panel, select Restore to restore all held jobs stored in the printer hard disk.
For non‑touch‑screen printer models, press
•
From the printer control panel, select Do not restore if you do not want any print jobs to be restored.
For non‑touch‑screen printer models, press
Scanner automatic feeder cover open
Close the ADF cover.
"Using genuine Lexmark parts and supplies" on page
"Using genuine Lexmark parts and supplies" on page
imaging unit
to confirm.
to confirm.
209.
is installed:
209.
243