Furuno MFD8 Installation Manual page 59

Name
Position & Choose the position-fixing
SOG/COG sensor to use.
Heading Choose the heading sensor
to use
Speed Through Choose the speed (STW)
Water sensor to use.
Water Depth Choose the depth sensor to
use.
Water Choose the temperature
Temperature sensor to use.
Wind Choose the wind sensor to
use.
Date & Time Choose the date and time
source to use.
Roll and Pitch Choose the motion sensor
to use.
AIS Choose the AIS equipment
to use
Note: If a NMEA0183 Instruments does not appear as a selection in the list, make sure
that the Input Type was correctly connected and assigned at each MFD (in the "Own"
configuration). Please refer to the "NMEA0183" paragraph p.51.
Note: Generic NMEA2000 instrument will appear as a selection for any type of data.
Select the correct Data Source or leave the default selection if no other instruments are
available.
-If you don't have any DRS (Radar) and Network sounder click on "Save & Exit" to finish
the installation. If you have a radar or sounder, click on "Next" to continue the
configuration.
Description
GP-320B, GP-330, SC30, Generic NMEA2000 GPS
SC-30, SC-50 (@10Hz), PG-500 (@10Hz), Generic
NMEA2000 Heading sensor
Smart sensor (NMEA 0183 or NMEA2000),
Transducer with Speed sensor (DFF1/DFF3)
Smart sensor (NMEA 0183 or NMEA2000), DFF1,
DFF3
Smart sensor (NMEA 0183 or NMEA2000),
Transducer with Temp sensor (DFF1/DFF3)
FI-501/502, PB-150, WS-200, Generic NMEA2000
wind sensor
GP-320B, GP-330, SC30, Generic NMEA2000 GPS
SC-30, SC-50, SC110
FA-150, FA-30, FA-50, Generic NMEA0183 AIS
59
Example