Furuno MFD8 Installation Manual page 48

Note: A "No Master Warning window" can appear to inform you than a Master is not yet
configured. If this is the case, simply click on "Installation Wizard" to configure the
Master.
Note: If the Master Selection does NOT appear, this means that there is already a MFD
set as a Master on the network. If you want to change the Master setting to another
MFD, you will have to turn the Master setting to OFF (on the MFD that is currently the
Master) and restart the system to turn the Master ON on another MFD.
- When the MFD turns OFF (after being set up as a Master), make sure that every other
MFD in the network are turned OFF and correctly wired to the HUB.
- Turn ON the Master MFD, then every slave on the network. Make sure that the LED
on the HUB shows good traffic information (for the MFD, DFF1, DRS...)
- The Installation Wizard launches on every MFD and begins to scan the devices
available on the network. Do not click on Skip. This will allow the scanning process to
end normally.
Note: If the Installation Wizard doesn't launch on the MFD, go to the [MENU] then
"System" and select "Installation Wizard".
- During the Installation Wizard countdown make sure that all MFD(s) see the Radar
and Sounder (if you missed the countdown, look for the Radar and Sounder tab in the
Installation Wizard: if they appear, radar and sounder are correctly detected).
Note: If the Radar and Sounder are not available on one MFD, you will need to
troubleshoot the Ethernet connections (cables). Power OFF the MFD, make sure the
connections are OK, repower the MFD and launch the Installation Wizard (and make
sure it sees the Radar and/or Sounder).
Important: If you are using an MFDBB, the Keyboard will not work until it is properly
"Linked" to a processor unit. Please refer to the paragraph "
48