new names on the left column, don't forget to push the "Set" button (lower right) in order
to validate the new names.
Note: If you have not renamed the NMEA0183 ports from their own tab, this page will
display the NMEA0183 Input Ports of every MFD connected to the network as "Port1",
"Port2" and "Port3". Each port refers to the MFD listed just above.
3.4.3. IP Camera
You can assign names to each connected IP Camera. These names will be used by the
RotoKey and for the Video ID in the main interface.
Note: If the IP camera selection is unavailable, make sure that it has a correct IP
address (Refer to the Appendix "Configuring AXIS IP Camera")
3.4.4. Primary Data Source selection
IMPORTANT: As explained in the "NMEA0183" p.51, if you have NMEA0183 sensors
connected to the input ports of MFD(s) on the network, you first need to configure the
"Own" settings for each MFD(s) before being able to select the corresponding
instruments as a data source.
57