Installation Wizard Own Settings; Monitor (Mfdbb Only); Nmea2000 Data Configuration - Furuno MFD8 Installation Manual

MFDBB Keyboard/Processor Linking" p.65 to properly link the MFDBB keyboard at this
time
When the Radar and Sounder (if applicable) are correctly detected, you can continue
the installation on the Master MFD.
3.3.

Installation Wizard Own Settings

3.3.1. Monitor (MFDBB only)

On the MFDBB, you can set up the video output resolution (DVI or VGA). Leave it to
Auto when you use a Furuno monitor.
You can also set up the Clone or Extended mode
Note: If only one monitor is connected to the MFDBB, leave the setting to "Clone"
Please refer to the "External Monitors" paragraph on p.37 for more information on Clone
and Extended mode when two monitors are connected to a single MFDBB processor.

3.3.2. NMEA2000 Data Configuration

This page configures the information that the MFD will output on its own NMEA2000
port. The information embedded in the PGN will be the information coming from the
Sensor that will be chosen as the Primary Source (see next paragraph). Enable each
49