Audio Technica ATW-T3202 User Manual page 20

Setting ATW-R3210N
Setting group/channel editing
Setting group/channel
Aside from the ten preset groups, there are two additional user-defined
scan groups: U1 and U2. Both U1 and U2 can be edited with up to 32
frequencies.
• All channels are vacant in the initial state.
1. From the menu screen, turn the control dial, select [UTILITIES]
and then press the control dial.
2. Turn the control dial, select [Gr/Ch EDIT] and then press the
control dial.
3. Turn the control dial, select [EDIT] and then press the control
dial.
4. Turn the control dial, select a group and then press the control
dial.
5. Turn the control dial, select a channel and then press the control
dial.
6. Turn the control dial, select [SET] or [RESET] and then press the
control dial.
• By pressing [SET], you can set the frequency of the selected channel.
• If you press [RESET], the frequency of the selected channel becomes
blank.
7. After setting all channels, turn the control dial, select [Sync] or
[Save] and then press the control dial.
• If you press [Save], the setting is completed.
• If you press [Sync], the screen turns to an IR SYNC standby screen. Refer
to "Using IR SYNC" (p. 14) for subsequent steps.
Syncing the Group/Channel
The U1 or U2 Groups/Channels that have been set, as outlined above,
can be sent to the transmitter via IR SYNC.
1. From the menu screen, turn the control dial, select [UTILITIES]
and then press the control dial.
2. Turn the control dial, select [Gr/Ch EDIT] and then press the
control dial.
3. Turn the control dial, select [Gr/Ch SYNC] and then press the
control dial.
4. Turn the control dial to select group and then press the control
dial.
• The screen turns to an IR SYNC standby screen. Refer to "Using IR
SYNC" (p. 14) for subsequent steps.
Setting the backup frequency mode
If you set the backup frequency in advance, you can switch the
frequency of the transmitter and receiver with the transmitter. It is
convenient to set this function when you want to switch the frequency
easily.
• The default setting is [Off].
1. From the menu screen, turn the control dial, select [UTILITIES]
and then press the control dial.
2. Turn the control dial, select [BACKUP FREQ] and then press the
control dial.
3. Turn the control dial, select [On] and then press the control dial.
4. Turn the control dial, select [Manual] or [Gr/Ch] and then press
the control dial.
• If you select [Manual], you can set the frequency.
• If you select [Gr/Ch], you can set the group/channel.
5. After setting each item, turn the control dial, select [Set] or
[Sync] and then press the control dial.
• If you press [SET], the setting is completed but you must still sync the
setting with the transmitter or set the backup frequency manually on the
transmitter in order to use the backup frequency.
• If you press [Sync], the screen turns to an IR SYNC standby screen.
Execute IR SYNC.
• After IR SYNC is complete, the transmitter's function button switches to
"Bkup Freq". (p. 24).
Setting the layout of the main screen
Select the item to be prominently displayed at the center of the main
screen.
• The default setting is [Frequency].
1. From the menu screen, turn the control dial, select [UTILITIES]
and then press the control dial.
2. Turn the control dial, select [DISPLAY] and then press the
control dial.
3. Turn the control dial, select [Frequency] or [Name] or [Gr/Ch]
and then press the control dial.
• The setting is complete.
19