Kit Contents - Enterasys RoamAbout RBT-8100 Installation Manual

The bracket kit allows you to install the RBT‐8100 Wireless Switch into most four‐post rack and
cabinet systems. The only tool required is a Phillips screwdriver.

Kit Contents

• Two chassis brackets
• Two rear brackets
• Two L brackets
• 1 fastener pack that includes the following:
Mounting in a Four-Post System
To mount the chassis in a four‐post system, perform the following steps:
1. If your chassis has chassis handles attached, remove the screws as shown in Figure
handles and screws aside for reattachment later.
A
B C D
Bracket Kit Installation
A. Eight #10-32 x 1/2-inch screws
E F
B. Four #6-32 x 3/16-inch screws
C. Two #10-32 x 7/8-inch screws
D. Two handle spacers
E. Four nut bars
F. Two chassis disks
RBT-8100 Wireless Switch Installation Guide 2-1
2
2‐1. Set the