Mounting in a Four-Post System
Figure 2-1
2.
Attach the chassis brackets to the chassis as shown in Figure
a.
b. Align the holes (B) in the bracket with the tabs (C) on the chassis and place the bracket
c.
d. Repeat step a through step c to attach a chassis bracket to the other side of the chassis.
Figure 2-2
3.
Attach disks to the chassis as shown in Figure
a.
b. Install the screw and tighten.
2-2 Bracket Kit Installation
Removing a Handle from the Chassis
Place a chassis bracket along one side of the chassis in the front‐mount position (A).
against the chassis. Slide the bracket toward the front of the chassis to the end of travel.
Fasten the bracket to the chassis using a screw (D).
Installing a Chassis Bracket in the Front-Mount Position
A. Chassis bracket in front-mount position
B. Bracket holes
C. Chassis tabs
D. #6-32 x 3/16-inch screw
Attach a chassis disk (A) at the side of the chassis towards the rear.
2‐2.
C
A
2‐3.
B
D