Enterasys RoamAbout RBT-8100 Installation Manual page 39

6. Enable the MSS DNS client:
RBT-8100# set ip dns server enable
7. Enable the auto‐config option:
RBT-8100# set auto-config enable
8. Create a self‐signed administrative certificate, to enable RASM or WebView to communicate
with the RoamAbout wireless switch. (See Step 4 in Example 1: Deployment Site Has DHCP
and Local DNS on page 3‐5.)
9. Save the configuration changes:
RBT-8100# save config
10. Power off or restart the switch.
Example 4: Deployment Site Has DHCP But Local DNS Domain Differs From
Corporate DNS Domain
The deployment site in this example has a DHCP server, so the switch's DHCP client is enabled.
Static IP address and default gateway information are not required. The site also has a local DNS
server. However, the local DNS domain name is different from the corporate DNS domain name
where the RASM server is located. The static DNS configuration on the switch overrides the DNS
configuration from the DHCP server.
1. Configure a VLAN:
RBT-8100# set vlan 1 port 1
2. Enable the DHCP client on VLAN 1:
RBT-8100# set interface 1 ip dhcp-client enable
3. Configure the default DNS domain name:
RBT-8100# set ip dns domain customer.com
4. Configure DNS server information:
RBT-8100# set ip dns server 192.168.11.2
5. Enable the MSS DNS client:
RBT-8100# set ip dns server enable
6. Enable the auto‐config option:
RBT-8100# set auto-config enable
7. Create a self‐signed administrative certificate, to enable RASM or WebView to communicate
with the RoamAbout wireless switch. (See Step 4 in Example 1: Deployment Site Has DHCP
and Local DNS on page 3‐5.)
8. Save the configuration changes:
RBT-8100# save config
9. Power off or restart the switch.
Wireless Switch Configuration Tasks
RBT-8100 Wireless Switch Installation Guide 3-7