Enterasys RoamAbout RBT-8100 Installation Manual page 27

6. Attach the chassis brackets, as shown in Figure
and one nut bar (C) per side.
Figure 2-6 Attaching a Front Bracket to a Front Post
A. Front post
B. Screw
C. Spacer
7. If your chassis came with handles attached (which were removed in step
handles as shown in Figure
a. Slide a handle (A) between the chassis and the chassis bracket.
b. Align the hole in the handle with the unused hole in the chassis bracket.
c. Install a spacer (B) between the handle and the chassis bracket.
d. Install and tighten screw (C) to secure the handle.
e. Repeat step a through step c to attach the handle to the opposite side.
2‐6, to the front posts (A) using two screws (B)
B
2‐7.
Mounting in a Four-Post System
A
1), install the chassis
RBT-8100 Wireless Switch Installation Guide 2-5
C