Enter Programming Mode; Exit Programming Mode - Chamberlain Elite EL25 Quick Start Manual

Enter Programming Mode

If you will be programming the unit via modem, please refer to the Versa XS online help.
Important:
After entering programming mode for the first time, we suggest you change
the password to maintain the security of your system.
From the EL25 Keypad:
1
1 Press
2 Enter the (6) six-digit password. The default is six zeroes.
From the Residence Telephone:
2
1 When you hear the dial tone, press
1A If multiple EL25 units are sharing the same phone line, then a Unit ID Code (1-7) will need
to be entered at this time.
2 Enter the (6) six-digit password. The default is six zeroes.
and the tone will stop.
3 Press
From the Remote Telephone:
2
1 Dial the unit's phone number.
Note: If the EL25 and an answering machine (or answering service) utilize the same phone line, let the line
ring at least (2) two times, hang-up, and call back within one (1) minute. The EL25 will answer on the
second call. If the unit does not answer, you may need to change the ring count.
2 When the EL25 picks up the call, you will hear 2 beeps.
3 Press
3A If multiple EL25 units are sharing the same phone line, then a Unit ID Code (1-7) will need
to be entered at this time.
4 Enter the (6) six-digit password. The default is six zeroes.
5 Press
and the beeps will stop.
• Press on the EL25 keypad and the unit will respond with
Press on the telephone and the unit will respond with
•
Press
programming sequence and exit programming mode.
The unit is now ready to accept programming instructions!
The unit is now ready to accept programming instructions!
The unit is now ready to accept programming instructions!

Exit Programming Mode

when using a telephone or the EL25 to cancel
Page 7
***
2 Short Beeps
0
3 short beeps when disconnecting.
3 short beeps when disconnecting.