Chamberlain Elite EL25 Quick Start Manual page 14

Step 2
Set Each "Relay
There are 5 different relay modes. The Relay Mode determines what the response will be when a valid access
code is entered (open a door, turn on an alarm, turn on a light then turn it off, turn on a CCTV, etc.).
Factory Setting: All Relays are Set at "1 - Strike"
1 Press Then
2 Enter the Relay Number (1-4). Then (
3 Enter Relay Mode (0-5). Then (
0 = Not Used
1 = Strike - controls a door/gate by unlocking/opening it.
2 = Shunt - bypasses the alarm under normal circumstances.
Example:
Step 3
Set Each Relay's
This is the amount of time (in seconds) the relay remains activated. This will define the amount of time a
door cycles (unlocks, then relocks) or how long the CCTV camera remains on after being activated.
Factory Setting: All Relays are set at 10 seconds
1 Press Then
2 Enter the Relay Number (1-4). Then (
3 Enter Activation Time (1-300 Seconds). Then (
Example:
When Activated, the Relay Number "4" will activate for "30" seconds.
Note: A relay that controls a gate operator must be set to activate for 2 seconds .
Step 4
Assign "Each" Door Number to One or More Relays:
When a valid access code is used at an external access control device (Door), the EL25 can be set to activate
Factory Settings: Door 1 Activates Relay 1; Door 2 Activates Relay 2;
one or more relays.
Door 3 Activates Relay 3; Door 4 Activates Relay 4
1 Press Then
2 Enter Door Number (1-4). Then (
3 Enter Relays to be Activated (0000-1111). Then (
0 = Deactivate , 1 = Activate (1st digit=Relay 4, 2nd digit=Relay 3, etc.)
Example:
When a Resident uses a Valid Code at "Door 1", Relay "1" and Relay "2" will Activate.
Mode" to get the Appropriate Response:
# )
# )
1
Assigns Relay "2" as a Shunt Relay
66
"Activation Time":
)
#
# )
1
# )
# )
1 2
Page 13
65
Important:
performed for EACH Relay assigned
to the unit.
3 = CCTV - activates system's optional camera.
4 = Alarm - activates another device (siren).
5 = Control - controls another device (on/off light).
2 3
1
Important: Allthroughepsmust be
performed for EACH Relay assigned
to the unit.
2 3
61
1
Important: Allthroughepsmust be
performed for EACH Door Number
assigned to the unit.
Relay 4 Relay 3 Relay 2 Relay 1
Deact Deact Activate Activate
1 3
Allthroughepsmust be
3
3
3